Our TWT white super heavy-duty 20 litre detailing bucket. Perfect to use in a 2 or 3 Bucket wash method.

How to use the 2 bucket wash method:

STEP 1: RINSE BUCKET

Take one bucket and fill it with water and a Dirt Guard. This will be your rinse bucket and will be the first stop for your filthy wash mitt after you pull it off the car.

STEP 2: WASH BUCKET

Fill a second bucket with a dirt trap and 1 – 3 oz of your favorite Chemical Guys soap. This will be your Wash Bucket, which is the second stop for your wash mitt. Activate the suds by spraying high pressure water into the bucket.

STEP 3: RINSE CAR

Rinse the car using pressurized water only to remove the largest dirt and debris, getting rid of it before you even have a chance to put mitt to paintwork.

STEP 4: WASH CAR

Dip wash mitt into soapy water and wipe car from top to bottom in straight lines, one small section at a time. When the mitt has become soiled, remove it from paintwork.

STEP 5: WRING WASH MITT

Wring mitt out over the ground away from your vehicle. This will purge the majority of the dirt and debris on the floor, so it doesn’t wind up in your rinse bucket and off your car.

STEP 6: WASH THE MITT

Return the soiled wash mitt to the rinse bucket first. Rub the dirty wash mitt against the Dirt Trap to agitate the stuck-on dirt, causing it to fall off the mitt and into the trap below. When all dirt has been dislodged, remove it from the rinse bucket, and wring out.

STEP 7: RESOAP MITT & REPEAT

Place clean wash mitt back into the wash bucket to soap it up again. Repeat process until entire car is clean, then rinse and dry car.